Hearthstone deck

Polo1.4 engine (1.4-liter Polo engine news: mechanical wonder) With the continuous development of science and Hearthstone decktechnology, the automobile industry is also constantly innovating. Among them, the engine is one of the key parts of the car. With the popularity of new energy vehicles, the improvement of internal combustion engines is inevitable.Nowadays, the Polo1.4 engine is an eye-catching product in the automotive industry. Polo1.4 engine basic parameters Polo1.4 engine is a four-cylinder 16-bal valve turbocharged engine equipped with a fuel injection system and an electronic control system. It has a displacement of 1.4 liters, a maximum power of 110 horsepower and a maximum torque of 200 Nm. According to the test data, this engine can accelerate from 0 to 100 kilometers in 10 seconds. The Polo1.4 engine is a high-efficiency and energy-saving product with an average fuel consumption of 5.8 liters per 100 kilometers. At the same time, the engine meets European emission standards and is widely used in Volkswagen models such as Polo. Features The Polo1.4 engine has many excellent functions. First of all, it adopts turbocharging technology.The turbocharged engine compresses the intake air through the turbocharger and sends it into the combustion chamber to improve the compression ratio and air intake of the engine, thus improving the engine power and torque. Therefore, it can provide stronger acceleration performance when the engine speed is low. In addition, the Polo1.4 engine also adopts in-cylinder direct injection technology. In-cylinder direct injection technology refers to injecting fuel directly into the engine cylinder, rather than injecting fuel into the intake channel. This can make the fuel fully burned, improve the thermal efficiency of the engine, and reduce fuel consumption and emissions. Therefore, the Polo1.4 engine has excellent energy-saving and environmental protection performance. In addition, the Polo1.4 engine is also equipped with a variable valve timing system. The variable valve timing system refers to the installation of an electronic control device on the valve timing mechanism of the engine, according to the developmentDepending on the working load conditions of the motive, the valve timing and valve lift are automatically adjusted to optimize the inlet and exhaust efficiency of the engine, so as to improve the output power and fuel utilization of the engine. This technology can help drivers better control the vehicle, while better adapting to different driving environments, and improve driving comfort and safety. Maintenance For the Polo1.4 engine, proper maintenance and maintenance are very important, so as to ensure its performance and life. First of all, change the oil and filter regularly. Oil is the lubricant of the engine, and the filter can filter the impurities in the oil. If the oil and filter are not replaced in time, it will affect the efficiency of the engine and even cause damage to the engine. Secondly, replace the cigar case and ignition plug regularly. Cigar sleeves and ignition plugs are the key parts of the engine ignition system.If it is not replaced in time, the ignition system will not work properly, the engine will be unstable or unable to start. Finally, check and clean the engine intake duct and exhaust pipe regularly. Cleaning can remove dust and debris from the air filter and intake duct to keep the engine working normally. Summary: The Polo1.4 engine is an advanced turbocharged engine, which adopts in-cylinder direct injection and variable valve timing technology, with excellent power, fuel economy and environmental protection performance. In order to ensure the performance and service life of the engine, the driver should properly maintain and maintain the engine. In the future, with the continuous development of automotive technology, the upgrade and improvement of the Polo1.4 engine will be an important development direction for the automotive industry.

Contact Us
Phone：020-83484621