bingo plus update today

Analysis and bingo plus update todayprecautions of the whole process of engine installation The engine is the core component of the motor vehicle, and the installation quality of the engine is directly related to the safety and stability of the vehicle.Therefore, when installing the engine, special attention should be paid to some details and precautions. This article will systematically introduce and explain the process and key points of engine installation from the two aspects of the analysis of the whole process of engine installation and the precautions. 1. Analysis of the whole process of engine installation 1.1 The first step of dismantling the old engine and installing the engine is to disassemble the old engine. When disassembling the engine, it is necessary to confirm the engine model, internal design and the specific parts of the fault, and mark and retain the relevant parts. In addition, attention should be paid to protecting other vehicle parts during the disassembly process, and the disassembled parts should be properly stored. 1.2 After installing the new engine and disassembling the old engine, the new engine needs to be installed on the vehicle. In this process, it needs to be installed according to the engine.In the order of installation, first fix the base and bracket of the engine, then install the oil pump, intake manifold, air conditioning compressor and other related accessories, and finally carry out the relevant connection work of the engine itself, including fuel pipeline, cooling water pipeline, electrical line, etc. Finally, it is necessary to test and debug various systems of the vehicle to ensure the quality of engine installation and the driving performance of the vehicle. Two. Notes on engine installation 2.1 Ventilation environment When installing the engine, it is necessary to ensure a ventilated environment, because some harmful gases, such as carbon monoxide, will be produced during the use of the engine, which will cause damage to the health of personnel in the workshop. Therefore, it is necessary to ensure that the workshop is well ventilated before installation, and to test at any time during the installation process to ensure that the gas concentration is within the safe range.2.2 Personnel safety The engine is relatively large and heavy, and the engine itself is a complex equipment, so special attention should be paid to the safety of operation when installing. It is necessary to ensure the safety of operators. All personnel must wear relevant safety protective equipment, such as safety helmets, goggles, gloves, etc., and abide by safety standards. 2.3 Ensure the integrity of parts. During the installation and disassembly of the engine, we need to repeatedly confirm the integrity of the engine and parts. When we disassemble the old engine, we need to be extra careful and register it well to avoid damage, loss and wrong parts. After installation, all connecting parts should also be carefully checked to ensure that all connections are fixed and suitable. 2.4 Engine use After the new engine is installed, the fuel system is required., check the cooling system, electrical system, etc. to ensure that all installed and connected parts are in normal operation. Then, the engine should be induced to run and test drive. During the test drive, it is necessary to observe the running quality of the engine, such as pulling a single cylinder, horsepower in road conditions, etc. Finally, in the trial operation, if it is necessary to eliminate the improper points, we must try our best to do a good job of overhaul and adjustment to ensure that the engine is in a normal working environment. Summarizing engine installation is a complex and meticulous work, and special attention needs to be paid to the details and precautions in all aspects. Accurate operation process and safety specifications can ensure the quality and safety of engine installation, and further improve the performance of the vehicle.

Contact Us
Phone：020-83484621